yzreobeb
Apr 12, 2018

Do you raise your eyebrows when being sarcastic?

0 comments

Hello,

 

I wish there was a sarcastic smiley with somone peering over their specs with their eyebrows raised, in a mock teacher stylee. Do you raise your eyebrows when being sarcastic? i want to know better about this.

I am curious about it.What is your opinion?

 

Please help.

 

I didn't find the right solution from the Internet.

 

References:

https://bit.ly/2JDlVsO

Website Promo Examples

 

Thanks!

 

 

 

 

 

New Posts
  • slayalicantov
    Oct 18

    Thank you again for posting this info about 419 fraud , this definitely helps me to understand how to treat her better and how to be around her without suffocating her. For me it’s a little harder because I want to be involved in her life just by knowing about her day and encouraging her through the day but I don’t want to be annoying. How can I do that? How can I encourage her without being annoying so it feels like she is being overwhelmed?
  • yzreobeb
    Oct 4

    Hi, How long does each rider take the lead position for when alternating as a duo to obtain maximum benefit? Presumably it depends on when the lead man feels he's had enough..but I wondered if it was, say, 30seconds or a couple of minutes each at the front? I went with my pal David today and we both coasted when following but I tired after only about 30secs leading - on the flat at about 25mph. Any help will be apprecited. I didn't find the right solution from the Internet. References: https://www.bikeradar.com/forums/viewtopic.php?t=12648218#p15591854 Data Analysis Software Example Thank you.
  • yzreobeb
    Oct 29

    Hi, I've had my up box for about a week now, I've completed 2 smaller prints and one larger 18 hour print before I started to run into problems. I loaded up another 18 hour print and it started fine. About two hours into the print it began to air print and no more filament was passing through the nozzle. I cancelled the print and cleaned out the extruder and nozzle. I've also cleaned the gear with some acetone and a metal bristled brush. I set up the print again and it begun like before, but soon was back to air printing. If i pause the print job I can extrude the filament perfectly. I Am really confused as to why it can extrude without hassle but doesn't complete the print. Am I doing something wrong or missing a step in the printing process? Any help would be appreciated. Please help. I didn't find the right solution from the Internet. References https://www.up3d.com/dami/viewtopic.php?t=55079 Digital Marketing Communication example Thanks

(313) 268-3739

460 Hilton Rd, Ferndale, MI 48220, USA

  • facebook
  • googlePlaces
  • instagram
  • twitter

©2016 by Slipstream Theatre Initiative. Proudly created with Wix.com